Yarbo Lights Flashing Different Colors Alternately

If you observe your Yarbo light consistently cycling through red-green-blue-white flashes, it may indicate an underlying issue. This troubleshooting guide is designed to assist you in identifying the potential causes behind the blinking and offers step-by-step solutions to address these problems.

1. Yarbo Connected to the Internet, Lights Still Flashing After Firmware Upgrade:

• Restart your Yarbo device.
• Utilize the Yarbo Tool to perform a deep clean for the disk memory.
• If the issue persists, contact us for support.

2. Yarbo Device Not Connected to the Internet, Lights Always Flashing Different Colors:

• Restart your Yarbo device.
• If the issue persists, use the Yarbo Tool to perform a deep clean for the disk memory.
• Connect to the internet and initiate the firmware upgrade process. The process could take at least one hour.
  
• Wait for the upgrade to finish. 
  
• Monitor for consistent operation.
• If the issue still persists, contact us for support.

3. Lights Flash Inconsistently Due to Power Interruption During Firmware Upgrade:

• Restart the Yarbo device and resume the firmware upgrade.

4. Lights Flash After Losing Network Connection During a Firmware Upgrade:

1. Restart the Yarbo device.
   
2. Reconnect to the internet, restart the upgrade, and monitor for consistent operation.
   

5. Lights Flash Without Recent Firmware Upgrades or Changes:

1. Restart your Yarbo device.
   
2. If the issue persists, use the Yarbo Tool to perform a deep clean for the disk memory.
   
3. Connect to the internet and initiate the firmware upgrade. Wait for the upgrade to finish.
   
4. Monitor for consistent operation.
   
5. If the issue still persists, contact us for support.
   

• Related Articles

• Yarbo Tool

  Yarbo Tool is available to help with diagnosing and fixing connectivity issues, troubleshooting, and checking/updating firmware. You can download the software here: Video: How to Use the Yarbo Fix Tool? The Yarbo Tool should be used in the following ...

• Charging Instructions for Yarbo

  Charging Yarbo with the Wired Charger Before charging Yarbo, check the voltage switch on the wired charger and set it to your home's AC voltage. Connect the wired charger to an electrical outlet and the charging port under the rear cover of Yarbo. ...

• Yarbo Network Status Readings

  Network: - MQTT: This stands for Message Queuing Telemetry Transport. It's a network protocol often used in the Internet of Things (IoT) for device-to-device communication. It works on top of TCP/IP and is designed for situations where a small code ...

• How to Install and Use Yarbo Tool

  Yarbo Tool is available to help with diagnosing and fixing connectivity issues, troubleshooting, and checking/updating firmware. You can download the software here: Video: How to Use the Yarbo Fix Tool? The Yarbo Tool should be used in the following ...

• Charging Station Indicator Lights

  Light Cause Action Green solid light Good signals Usual operation of the product. Green flashing light The signals are good and ECO mode is enabled. Usual operation of the product. Refer to ECO mode in User Manual Blue flashing light The boundary ...