Work Area Tampered / Radar problem (Error Message)

Work Area Tampered / Radar problem (Error Message)

  1. Move one waypoint (just a couple of inches) then reinstall charging station,

  2. Perform an Ultrasonic Sensor Test using Autocheck.

    • Related Articles

    • Charging System Problem/Error Message

      Possible cause: Temporary electronic or firmware related issue in the product Diagnostic steps: Turn the product off and on Clean the charging plates and contact plates There may be corrosion or dirt on the charging plates and contact plates. Clean ...

    • EPOS Error/Fault Messages

      The fault messages in the table below are shown in the Automower® Connect app. Message Cause Action Cutting system blocked The blade disc is blocked by grass or other objects. Examine the blade disc and remove the grass or other object. The blade ...

    • EPOS - How to Map Work Areas within another Work Area

      This example shows a Golf Course that needs to have smaller work areas cut at a different height that the main work area.

    • How to view the last Work Area mowed

      To view the last Work Area mowed after an operation: Go to the AMC App Click on “Map” Map will show last mowed area highlighted in green

    • How to Set Parameters for a Work Area?

      Where to find the Area Settings page? Method 1: Accessing Area Setting from Modify Page Access 'My Map' Page: Begin by clicking on the icon located in the upper-right corner, directing you to the 'My Map' page where you manage and customize your map ...