What is the Maximum Loop/Perimeter and Guide wire length?
Please note that reaching or
exceeding these guidelines, can result in a weakened signal:
- Making harder for the mower
to find the wire or return home
- Causing behavior issues
with mower due to weakened signal
Related Articles
Wire Break/finding break in the loop wire.
The fault message No loop signal is displayed when the Automower® robotic lawn mower is not able to detect the loop signal from the boundary wire. Possible causes: Actual break in the wire Bad connection at the charging station Damaged or water ...How to repair a perimeter wire break?
Perimeter write is built to withstand a lot. But that doesn’t mean it’s invincible. Maybe an animal causes the problem. Or mother nature creates destructive conditions for your wire. Or maybe it just wasn’t installed correctly in the first place. ...No Loop Signal – Yellow LED/Charging Station Indicator Lamp
Check that the guide wire connector is properly connected to the charging station. Replace the damaged section of the guide wire with a new loop wire. Break in the guide wire. Find out where the break is. Replace the damaged section of the guide wire ...No Loop Signal – Blue LED/Charging Station Indicator Lamp
What color is the Charging Station indicator lamp? The charging station LED is Solid Blue: Does the length of the boundary wire exceed 800 meters? A solid blue light on the charging station indicates a weak boundary wire signal. This is normally ...EPOS Installation | Support By Wire (NERA only)
In certain instances the EPOS charging station might need to be installed in an area which there is limited or no view of the sky (satellites). Note: EPOS™ Support by Wire is available for Automower® NERA robotic lawn mowers equipped with EPOS™ ...