1. Check if the breaker has popped? If yes, then reset it:
   Open the Enclosure and close the popped Breaker by pushing the E9 lever up.
   
   
2. Check the output settings are correct.
   
   

1. To turn on the unit, press and hold the black button (red circle) for three seconds.
2. Select either Output-1 or Output-2 based on your configuration.
   
   Note:
   The two output buttons next to the monitor are for turning on and off the charging station outputs.
           ON = Recessed
   
   
3. Open the Enclosure and close the popped Breaker by pushing the E9 lever up.
   
   Note:
   Once the unit is powered on, all of the displays should be on. Once powered on please set the desired parameter based on the automower that will be connected.
     
   

To select the current output, cycle through the screens by clicking left button on the Boost Converter until "Lo" (Location) is displayed.

This screen will display "Lo" and a # next to it (Lo - 0), 1 is the defaulted location on Output 2.

Mower settings:

Lo 1:       1.3A (Automower: 115H, 310, 315, 315X)
Lo 2:      2.2A (Automower: 520, 520H)
Lo 3:      4.3A (Automower: 430X, 430XH)
Lo 4:      7A (Automower: 450X, 450XH 435X, 535, 550, 550H and EPOS)
Lo 5:      Pairing Mode A (Automower: 430X, 430XH)

Note:
To perform the pairing mode, follow the previous steps of cycling through the different "Lo" (Locations). Click the ^ (up arrow) to cycle to "Lo" 5

For mowers that do not work with the solar charger's pairing mode (i.e. 115H, 310, 315 & 315X), these mowers should be paired according to the product manual, using standard mains electricity prior to connecting/installing to the solar charger.

Once the desired current has been selected & saved, click the "OK" button to activate the output. When the output is activated, the enclosure can be closed and the mower charging station can be connected to its designated output to low voltage connector (1 or 2). The mower charging station will power on and you can now charge the mower.