Robot will not turn on (new out of box)

Robot will not turn on (new out of box)

Possible causes:

●        Battery might be too low to turn on.

●        Faulty battery

●        Faulty robot

Diagnostic steps:

●        Make sure power outlet is working

●        Make sure power is connected correctly to charging station

●        Confirm charging station has Green Light

●        Leave robot on charging station for 24 hours then turn on

Procedures:

●        If robot does still not turn on, contact Dealer or Husqvarna to process a Warranty replacement.



    • Related Articles

    • Robot will not turn on/No light on base station

      Issue: Robot will not turn on/No light on base station Model/s: All Models Possible causes: ● Robot not turned on ● Bad power outlet or power cable not connected correctly ● Bad charge station board Diagnostic steps: ● Confirm Robot is turned on ● ...

    • Robot will not start mowing

      Possible causes: Robot not turned on Bad power outlet or power cable not connected correctly Bad charging station board Mower was previously mowing in a secondary area Override the schedule is set Diagnostic steps: Confirm Robot is turned on Confirm ...

    • Robot not mowing all Areas

      Possible causes: Not enough time scheduled.“ Lawn coverage” not setup correctly Guide wires not setup correctly Diagnostic steps: Check Schedule Check to make sure “Lawn Coverage” is setup correctly: Check each area distance Check each area % of ...

    • EPOS will not save a new systematic mowing direction?

      To change/set a different systematic mower angles for your EPOS: Open App then go to "My Mowers" the go to "Select your mower" Click on “Map" then select "Area" then select "Pattern" Change to your desired angle then click on "Save" on top right of ...

    • Robot Time is Incorrect

      If your Robot or App is showing the wrong time, follow below instructions to change: Make sure robot is turned on and unlocked. Go To: Menu then press OK Go To: Settings then press OK Go To: General then press OK Go To: Time & Day then press OK Go ...