Robot not mowing all Areas

Robot not mowing all Areas

Possible causes:

  1. Not enough time scheduled.“
  2. Lawn coverage” not setup correctly
  3. Guide wires not setup correctly
Diagnostic steps:

  1. Check Schedule
  2. Check to make sure “Lawn Coverage” is setup correctly:
         Check each area distance
         Check each area % of cutting time
  3. Perform a “Lawn Coverage” Test of areas with issue

Procedures:

Check “Lawn Coverage” settings:

  1. Make sure robot is turned on and unlocked.
  2. Go To: Menu then press OK
  3. Go To: Installation then press OK
  4. Go To: Lawn Coverage then press OK
  5. Go To: GPS Auto 430X/450X then press OK
  6. Go To: Overview of lawn coverage - then press OK
  7. Go To: Area (1-5) then press OK
  8. Go To: More then press OK
  9. Go To: Test - then press OK
  10. Follow instructions on screen.
This will test that robot can get to all Areas correctly

Notes:

You need to Turn Off “GPS Map” when setting up Areas
Make sure “GPS Auto” is Turned On once you have finished Testing


    • Related Articles

    • Robot will not start mowing

      Possible causes: Robot not turned on Bad power outlet or power cable not connected correctly Bad charging station board Mower was previously mowing in a secondary area Override the schedule is set Diagnostic steps: Confirm Robot is turned on Confirm ...

    • Robot Time is Incorrect

      If your Robot or App is showing the wrong time, follow below instructions to change: Make sure robot is turned on and unlocked. Go To: Menu then press OK Go To: Settings then press OK Go To: General then press OK Go To: Time & Day then press OK Go ...

    • How to Touch up Small Rusty Areas?

      The auger of your Yarbo might be rusted over time due to constant contact with snow during operation. You can easily manage these minor rusty areas with a paint pen. Here's a step-by-step guide to help you through the process: Preparation Prepare the ...

    • Robot will not turn on/No light on base station

      Issue: Robot will not turn on/No light on base station Model/s: All Models Possible causes: ● Robot not turned on ● Bad power outlet or power cable not connected correctly ● Bad charge station board Diagnostic steps: ● Confirm Robot is turned on ● ...

    • Robot will not turn on (new out of box)

      Possible causes: ● Battery might be too low to turn on. ● Faulty battery ● Faulty robot Diagnostic steps: ● Make sure power outlet is working ● Make sure power is connected correctly to charging station ● Confirm charging station has Green Light ● ...