Procedure after 4G Communications Board upgrade

Procedure after 4G Communications Board upgrade

All models, except 320, 330X and 330XH which are not compatible with the CBT5 board.

Description:

Due to the cancellation of the 2G and 3G cellular network, all Automower Connect boards Com-board 1, 3 and 4 (supporting 2G and 3G cellular network) have to be replaced with Com-board 5 (supporting 2G and 4G). This is valid for new Automower Connect kits in stock and for all Connect kits mounted in mowers.

Note: The mower will not stop working, it ́s only the ability to connect to the machine from a greater distance and the ability to track it if stolen that will be lost. It is still possible to connect to the mower via Bluetooth.

Procedures:

  1.  Install new comm board 597 31 72-05 (4G Connect Board) and update Firmware
  2. Use AutoMower®Connect App to Unpair Mower and Re-pair with new board
               o   Open App the GoTo “My mowers”   
               o   Click on “Unpair mower”
             o   Click on “+” sign in top right corner, then choose your mower model
  3.            o   Follow instructions on the mower Control Panel



    • Related Articles

    • How to upgrade the firmware version of Yarbo?

      Step-by-Step Network Setup For Firmware upgrade Guide: 1. Initial Notification: Upon receiving your Yarbo, please promptly inform Yarbo staff of the Yarbo Serial Number (SN) code. This code is located on the external packaging of the universal ...

    • Yarbo Lights Flashing Different Colors Alternately

      If you observe your Yarbo light consistently cycling through red-green-blue-white flashes, it may indicate an underlying issue. This troubleshooting guide is designed to assist you in identifying the potential causes behind the blinking and offers ...

    • No Loop Signal – Blue LED/Charging Station Indicator Lamp

      What color is the Charging Station indicator lamp? The charging station LED is Solid Blue: Does the length of the boundary wire exceed 800 meters? A solid blue light on the charging station indicates a weak boundary wire signal. This is normally ...

    • Robot will not turn on/No light on base station

      Issue: Robot will not turn on/No light on base station Model/s: All Models Possible causes: ● Robot not turned on ● Bad power outlet or power cable not connected correctly ● Bad charge station board Diagnostic steps: ● Confirm Robot is turned on ● ...

    • Collision Fault/Error Message

      Possible causes: Mower body is not fully attached Magnets missing or out of position Procedure: Make sure that the product body is fully attached to its fixing points Press each corner of the product to ensure that the product body is fully attached ...