No Loop Signal – Red LED/Charging Station Indicator Lamp
The charging station LED is Solid Red:
Fault in the circuit board or
incorrect power supply in the charging station. The fault should be rectified
by an authorized service technician.
Contact your local Husqvarna
dealer.
The charging station LED is Flashing Red:
The charging station’s antenna is
defective. This problem requires action by authorized service technician.
Contact your local dealer for
further investigation.
- Make sure to take the
complete product with you to the dealer. The complete product is the:
- Robotic lawn mower
- Charging station and power supply
Related Articles
No Loop Signal – Blue LED/Charging Station Indicator Lamp
What color is the Charging Station indicator lamp? The charging station LED is Solid Blue: Does the length of the boundary wire exceed 800 meters? A solid blue light on the charging station indicates a weak boundary wire signal. This is normally ...
No Loop Signal – Green LED/Charging Station Indicator Lamp
What color is the Charging Station indicator lamp? The charging station LED is Flashing Green: Procedures: Disconnect and reconnect charging station power supply. Note: ECO-mode is disabled when the power is disconnected. If you wish to enable ...
No Loop Signal – Yellow LED/Charging Station Indicator Lamp
Check that the guide wire connector is properly connected to the charging station. Replace the damaged section of the guide wire with a new loop wire. Break in the guide wire. Find out where the break is. Replace the damaged section of the guide wire ...
Charging Station Indicator Lights
Light Cause Action Green solid light Good signals Usual operation of the product. Green flashing light The signals are good and ECO mode is enabled. Usual operation of the product. Refer to ECO mode in User Manual Blue flashing light The boundary ...
Wire Break/finding break in the loop wire.
The fault message No loop signal is displayed when the Automower® robotic lawn mower is not able to detect the loop signal from the boundary wire. Possible causes: Actual break in the wire Bad connection at the charging station Damaged or water ...