No Loop Signal – Blue LED/Charging Station Indicator Lamp
What color is the Charging Station
indicator lamp?
The charging station LED is Solid Blue:
Does the length of the boundary wire exceed 800 meters?
A solid blue light on the charging station indicates a weak boundary wire signal. This is normally caused by a small break or damage in the boundary wire or a boundary wire exceeding the maximum recommended length.
If the answer is No: Contact your Husqvarna local dealer.
The charging station LED is Flashing Blue:
Check that the boundary wire
connector is fitted properly to the charging station.
Follow the instructions and check the charging station's indicator lamp.
- Switch the connections
between the guide wire and the boundary wire in the charging station. Start by
switching connections AL and G1.
Note:
Some models are marked with "GUIDE" or "G" instead of "G1".
Some models have additional guide wires (G2, G3). The same procedure can be followed for them. - Check the color of the
charging station's indicator lamp. You'll need to remember this color to answer
the question at the end.
- Put AL and G1 back to
their original positions.
- Switch connections AR
and G1.
- Check the color of the
charging station's indicator lamp. You'll need to remember this color to answer
the question at the end.
- Put AR and G1 back to
their original positions.
- Is the charging
station's indicator lamp from step 2 and/or step 5 flashing blue?
Check that the boundary wire connectors are fitted properly to the charging station
Make sure that the boundary wire connectors are connected to AR and AL. They should not be loose or damaged.
Replace the connectors if you suspect that the wire has corroded. If the wire seems to be fragile or the metal casing of the wire is loose when you wiggle the connector, this is a clear sign that the connector needs to be replaced. Search for Connector on the website to purchase new connectors.Note: Corrosion is a natural process that occurs over time. If you keep the installation outside over the winter, it's recommended to replace the connectors each year.
Tip: Purchase a connector protection box to protect the connectors from moisture, water, snow, etc. during off-season. Search for Connector protection box on the website or contact your dealer for more information.
Related Articles
No Loop Signal – Green LED/Charging Station Indicator Lamp
What color is the Charging Station indicator lamp? The charging station LED is Flashing Green: Procedures: Disconnect and reconnect charging station power supply. Note: ECO-mode is disabled when the power is disconnected. If you wish to enable ...No Loop Signal – Red LED/Charging Station Indicator Lamp
The charging station LED is Solid Red: Fault in the circuit board or incorrect power supply in the charging station. The fault should be rectified by an authorized service technician. Contact your local Husqvarna dealer. The charging station LED is ...No Loop Signal – Yellow LED/Charging Station Indicator Lamp
Check that the guide wire connector is properly connected to the charging station. Replace the damaged section of the guide wire with a new loop wire. Break in the guide wire. Find out where the break is. Replace the damaged section of the guide wire ...Charging Station Indicator Lights
Light Cause Action Green solid light Good signals Usual operation of the product. Green flashing light The signals are good and ECO mode is enabled. Usual operation of the product. Refer to ECO mode in User Manual Blue flashing light The boundary ...Wire Break/finding break in the loop wire.
The fault message No loop signal is displayed when the Automower® robotic lawn mower is not able to detect the loop signal from the boundary wire. Possible causes: Actual break in the wire Bad connection at the charging station Damaged or water ...