How to edit the 'Working Area'?
If any mistakes are made during the drawing process, there's no need to worry. You can click "Redraw" to start over. However, it's important to ensure that the working area you redrawn is connected to the previously drawn pathway.
Related Articles
How to Draw a Working Area?
The working area refers to the specific zones covered in snow where you intend for Yarbo to perform snow cleaning operations. The working area is a completely enclosed zone, and it cannot exist independently; it must be connected to the pathway you ...
Can I edit or split and area boundary?
You can edit a boundary by deleting or moving "Waypoints". To split a boundary you would have to delete all the relevant waypoints then add a new "Work Area". Note: If you have many Waypoints its quite often easier to just delete the Work Area and ...
EPOS only mowing border/stay out area border and not lawn
Solution 1: The issues could be that too many waypoints are used, Try removing some waypoints (so less points around stay out zones or other places on the boundary with many close points). Your map will look a bit boxier. Solution 2: The mower might ...
How to view the last Work Area mowed
To view the last Work Area mowed after an operation: Go to the AMC App Click on “Map” Map will show last mowed area highlighted in green
EPOS - How to Map Work Areas within another Work Area
This example shows a Golf Course that needs to have smaller work areas cut at a different height that the main work area.