How to Draw a Working Area?

1. The working area refers to the specific zones covered in snow where you intend for Yarbo to perform snow cleaning operations. 
   

1. The working area is a completely enclosed zone, and it cannot exist independently; it must be connected to the pathway you created earlier.

1. Guided Animation in Working Area Creation:

When entering working area creation, you'll encounter a guided animation. You can either click to choose ”Don't show again“ or directly click the "Confirm" button to proceed with the drawing.

2. Controlling Yarbo for Working Area Creation:

You now can control Yarbo to define and create the working area as needed. 

3. Completion of Drawing:

After completing the drawing, click on "Next" to proceed the configuration of Snow Throw Directions. 

4. Error Correction in Drawing:

If any mistakes are made during the drawing process, there's no need to worry. You can click "Redraw" to start over. However, it's important to ensure that the working area you redrawn is connected to the previously drawn pathway.

• Related Articles

• How to edit the 'Working Area'?

  If any mistakes are made during the drawing process, there's no need to worry. You can click "Redraw" to start over. However, it's important to ensure that the working area you redrawn is connected to the previously drawn pathway.

• How to Draw a Pathway?

  What is Pathway? A pathway is created to guide Yarbo to the specific area where work needs to be done. The Pathway is a line connecting the Docking Station to a Working Area and two separate Areas. How to Draw a Pathway? 1. Accessing the Mapping ...

• How to view the last Work Area mowed

  To view the last Work Area mowed after an operation: Go to the AMC App Click on “Map” Map will show last mowed area highlighted in green

• EPOS - How to Map Work Areas within another Work Area

  This example shows a Golf Course that needs to have smaller work areas cut at a different height that the main work area.

• Can I edit or split and area boundary?

  You can edit a boundary by deleting or moving "Waypoints". To split a boundary you would have to delete all the relevant waypoints then add a new "Work Area". Note: If you have many Waypoints its quite often easier to just delete the Work Area and ...