How to add more areas to an existing map?

How to add more areas to an existing map?

There are two ways to add more areas to an existing map. Please follow these steps for each method: 
Add more areas option will be shown after your working area has been drawn, the throwing direction has been selected, route mode has been set. 

Method 1: Adding More Areas from the Mapping Process
  1. During Mapping Area Process: While in the process of mapping the work area, after selecting the snow-throwing direction and proceeding to the route mode selection page, click on 'Next', and then click the 'Confirm' icon. 
  2. Pop-up Window: A pop-up window will appear, asking if you want to make other options. Click on ' Add More Area' to access the tool for creating more areas.
  3. Accessing More Area Creation: In the pop-up window, click 'Add More Areas' to initiate the creation of new areas.
  4. Drawing More Area: When drawing more areas, ensure that you start the pathway from the edge of the previous working area. After completing the pathway, proceed to draw the new area. 
  5. Completion: After drawing more areas, the subsequent steps remain the same as the initial area creation process.




Method 2: Add More Areas from the Modify Page
The additional areas need to be added starting from a specified area. Therefore, you need to first select a specific area. Subsequently, you can start drawing a pathway from this chosen area.
  1. Navigate to 'My Map' Page: Select the icon in the upper right corner to navigate to the 'My Map' Page. 
  2. Access Area Modification: Click on 'Modify' to access the Area modification mode. 
  3. Initiate Addition Process: Click "Add Area” to start the process of drawing a new area. 
  4. Draw Pathway: The process is similar to adding more areas in mapping, start by drawing a pathway. However, please remember that the starting point of this pathway should be within the area you selected in the previous step.



    • Related Articles

    • How do I add a Repeater Reference Station?

      If you need to increase the effective range of your EPOS or help eliminate "poor positioning" areas, you can add additional Reference Stations to the existing installation and use them a Repeaters. You will need to set the new Reference Station as a ...

    • EPOS - How to Map Work Areas within another Work Area

      This example shows a Golf Course that needs to have smaller work areas cut at a different height that the main work area.

    • Robot not mowing all Areas

      Possible causes: Not enough time scheduled.“ Lawn coverage” not setup correctly Guide wires not setup correctly Diagnostic steps: Check Schedule Check to make sure “Lawn Coverage” is setup correctly: Check each area distance Check each area % of ...

    • Cannot add Mower to AMC App 1

      Disconnect any other Bluetooth devices on the phone in Settings. (ipods, apple watch etc.) Forget existing mower on the phone by going in Settings> > Bluetooth , then tap on the device and "Forget this Device" (If the mower is visible under paired ...

    • EPOS - How to Map Using a Game Controller

      If you have used the App to Map Work Areas, you might have experienced how difficult it is the drive EPOS (especially in a straight line). The use of a Game Controller to drive (drop points etc.) can be very helpful and save a lot of time. The ...