How to Activate the Auger/Impeller When Drawing a Map?

If you need to draw working areas in the presence of snow, you could activate the auger to assist in clearing the snow in your way:

1. Open the control panel by clicking the button at the bottom right corner of the working area drawing page.
2. Choose the auger(Impeller) speed from the options available at the bottom left corner of the control panel.
   

     

• Related Articles

• How to add more areas to an existing map?

  There are two ways to add more areas to an existing map. Please follow these steps for each method: Add more areas option will be shown after your working area has been drawn, the throwing direction has been selected, route mode has been set. Method ...

• How to redraw your map?

  You can redraw the entire map. The process of redrawing is the same as the mapping process.

• EPOS - How to Map Using a Game Controller

  If you have used the App to Map Work Areas, you might have experienced how difficult it is the drive EPOS (especially in a straight line). The use of a Game Controller to drive (drop points etc.) can be very helpful and save a lot of time. The ...

• Where to Find Mapping Feature?

  Start Mapping from the onboarding tutorial After finishing the onboarding tutorial, proceed to the mapping preparations page and click on 'Next'. Subsequently, click the 'Finished' button to initiate the mapping process. Start Mapping from the Device ...

• EPOS - How to Map Work Areas within another Work Area

  This example shows a Golf Course that needs to have smaller work areas cut at a different height that the main work area.