EPOS stopped with Error “No accurate position from satellites”

EPOS stopped with Error “No accurate position from satellites”

If after “Searching for satellites” the status light turns off and you get “No accurate position from satellites” message on the App. Please follow the below steps to resume mowing from the stop point.


​Mower should pair with Bluetooth when you get close to it (blue blinking light) but might not give an option to reset. 
  1. Turn off the power switch on the bottom of the mower.  The mower will start beeping and the blue status light flashing.
  2. Open AMC app and check mower sensor data, the EPOS indicator should be spinning then change to a yellow triangle or green check mark.
  3. Toggle the stop start button on top of the mower and enter passcode.
  4. The mower should come back up in a paused state on the App.
  5. Start mower and select the work area it had stopped in.
  6. Mower state should change to searching for satellites on the App, once satellites are found it should return to the point it had stopped and resume mower.

    • Related Articles

    • EPOS Error/Fault Messages

      The fault messages in the table below are shown in the Automower® Connect app. Message Cause Action Cutting system blocked The blade disc is blocked by grass or other objects. Examine the blade disc and remove the grass or other object. The blade ...

    • EPOS Remote Troubleshooting using Autocheck

      Overview: Autocheck 3 (version 3.7 onwards) now has an option to view the following information for EPOS units, which will help pinpoint what and where errors occur. Note: This is historical data pulled from the Cloud Map details (with or without ...

    • EPOS Reference Station Winter Storage

      The EPOS Reference Station can be left outside during winter. If you keep the reference station outdoors during the winter, we recommend you keep the power supply connected. Indoor storage of EPOS reference station If you store the reference station ...

    • EPOS Installation | Support By Wire (NERA only)

      In certain instances the EPOS charging station might need to be installed in an area which there is limited or no view of the sky (satellites). Note: EPOS™ Support by Wire is available for Automower® NERA robotic lawn mowers equipped with EPOS™ ...

    • EPOS is not docking correctly

      If EPOS is having trouble docking correctly - it tries to dock but either shifts to left or right. Error message may say "Charging station obstructed". The charging station uses a radio signal to dock once its close enough (at docking point), so ...