Charging Station Indicator Lights
|
Light
|
Cause
|
Action
|
|
Green
solid light
|
Good
signals
|
Usual
operation of the product.
|
|
Green
flashing light
|
The
signals are good and ECO mode is enabled.
|
Usual
operation of the product. Refer to ECO mode in User Manual
|
|
Blue
flashing light
|
The
boundary wire is not connected to the charging station.
|
Make
sure that the boundary wire is correctly installed in the charging station.
Refer to To install the boundary wire in User Manual
|
|
Damage
in the boundary wire.
|
Find
out where the damage is. Replace the damaged section with new boundary wire.
|
|
Red
flashing light
|
Interference
in the antenna of the charging station.
|
Speak
to your Husqvarna customer service.
|
|
Red
solid light
|
Error
in the circuit board or incorrect power supply in the charging station. The
error must be corrected by an authorized service technician.
|
Speak
to your Husqvarna customer service.
|
Related Articles
No Loop Signal – Blue LED/Charging Station Indicator Lamp
What color is the Charging Station indicator lamp? The charging station LED is Solid Blue: Does the length of the boundary wire exceed 800 meters? A solid blue light on the charging station indicates a weak boundary wire signal. This is normally ...
No Loop Signal – Green LED/Charging Station Indicator Lamp
What color is the Charging Station indicator lamp? The charging station LED is Flashing Green: Procedures: Disconnect and reconnect charging station power supply. Note: ECO-mode is disabled when the power is disconnected. If you wish to enable ...
No Loop Signal – Red LED/Charging Station Indicator Lamp
The charging station LED is Solid Red: Fault in the circuit board or incorrect power supply in the charging station. The fault should be rectified by an authorized service technician. Contact your local Husqvarna dealer. The charging station LED is ...
No Loop Signal – Yellow LED/Charging Station Indicator Lamp
Check that the guide wire connector is properly connected to the charging station. Replace the damaged section of the guide wire with a new loop wire. Break in the guide wire. Find out where the break is. Replace the damaged section of the guide wire ...
Yarbo Charging Failure at the Docking Station?
Docking station has no power, the LED indicator is not illuminated If the Docking Station appears to be without power – indicated by the absence of illumination from the LED indicator – ensure that the Docking Station is properly connected to its ...